INTERNATIONAL PAINT CO.,(CALIFORNIA) INC. -- INTERNATIONAL THINNER, GTA007  -- 8010-00N008033
<pre>=====================  Product Identification  =====================

Product ID:INTERNATIONAL THINNER, GTA007
MSDS Date:01/01/1987
FSC:8010
NIIN:00N008033
=== Responsible Party ===
Company Name:INTERNATIONAL PAINT CO.,(CALIFORNIA) INC.
Address:220 S LINDEN AVE
City:SOUTH SAN FRANCISCO
State:CA
ZIP:94080-6411
Country:US
CAGE:5B898
=== Contractor Identification ===
Company Name:INTERNATIONAL PAINT CO
Address:220 S LINDEN AVE
Box:City:SOUTH SAN FRANCISCO
State:CA
ZIP:94080-6411
Country:US
CAGE:5B898

=============  Composition/Information on Ingredients  =============

Ingred Name:XYLENES (O-,M-,P- ISOMERS)	(SARA III)
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: 100%
OSHA PEL:100 PPM/150 STEL
ACGIH TLV:100 PPM/150STEL;9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

=====================  Hazards Identification  =====================

Effects of Overexposure:EYES:SEVERE IRRIT,RED,TEAR,BLUR
    VISION.SKIN:PRLNG/RPTD CONT CAUSES IRRIT,DERMATITIS,(SEE SUPP DATA)

=======================  First Aid Measures  =======================

First Aid:EYES:FLUSH IMMED W/PLENTY OF H*2O FOR @ LEAST 15 MIN,GET MED
    ATTN.SKIN:WASH W/PLENTY OF SOAP,H*20.RMV CONTAM CLTHG.IF IRRIT
    PERSISTS GET MED ATTN.INHAL:RMV TO FRESH AIR,IF BRTHG STOPS GIVE
    ARTF RESP,G ET IMMED MED ATTN,INGEST: (SEE OTHER PRECAUTIONS)

=====================  Fire Fighting Measures  =====================

Flash Point:83F (28C), SCC
Lower Limits:1.0
Extinguishing Media:FOAM,CO*2,DRY CHEMICAL.
Fire Fighting Procedures:USE H*2O TO COOL CNTNRS,NOT AS EXTINGUISHING
    MEDIA.
Unusual Fire/Explosion Hazard:CLSD CANS MAY EXPLO IF EXP TO EXT
    HEAT.ISOLATE FROM IGNITION SOURCES.DONT SPREAD BURNING LIQ W/H*2O.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION.AVOID PROLONG
    INHALATION OF VAPORS.VENTILATE AREA.CLEAN UP W/ABSORBANT MATERIALS.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN AREAS DESIGNED FOR OSHA CLASS
    IC FLAMMABLE LIQUID.
Other Precautions:EMER + FIRST AID PROC:DONT INDUCE VOMITING.GET MED
    ATTN.ASPIRATION OF INGESTED MATL INTO LUNGS FROM VOMITING CAN CAUSE
    CHEM PNEUMONITIS,POSS FATAL. VENT:WELD/FLM CUT SURFACE COATED
    W/PRODUCT.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NIOSH/MSHA APPROVED RESSP PROT DEPENDING ON
    CONDITIONS OF USE.
Ventilation:SUFF VENT TO KEEP < TLV,RMV DECOMP PROD IF (SEE OTHR
    PRECAUT
Protective Gloves:RECOMMENDED
Eye Protection:SFTY GLASSES/CHEM GOGGLES
Other Protective Equipment:FACE SHIELD TO PREVENT EYE CONTACT.
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:279F, 137C
Vapor Pres:5
Vapor Density:> 1
Spec Gravity:0.8714
Evaporation Rate &amp; Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:100

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE
Hazardous Decomposition Products:CO,CO*2,VARIOUS HYDROCARBONS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE IAW LOCAL,STATE & FEDERAL REGULATIONS.
    DO NOT INCINERATE UNOPENED CONTAINERS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.